Nortel WLAN Security Switch 2361 Installationsanleitung PDF herunterladen (Seite 51)

WLAN Series 2332 Outdoor Solution with Indoor Mounted AP 51

Avaya WLAN 2332 Series Outdoor Solution Guide

• has tested and measured each product. The antenna gains expressed in dBi measurements are the tested

values and may differ slightly from those published by Cushcraft for similar products.

Coax cable seal installation

Applying coax seal tape

You must weather seal all outside coaxial connections using the coax seal tape provided in the mounting kit.

Coax connections that are not properly sealed permit moisture to enter the connection, which leads to

performance degradation or link problems.

To apply the coax seal tape, follow these steps:

1 Make sure that the coaxial cables, connectors, and the connector area are clean and dry.

2 Peel the paper backing from a length of coax seal tape.

3 Wrap each connector with the coax seal tape, starting at the coaxial cable, extending across the connector

body, and finishing close the lightning arrestor surge suppressor or grounding block. Overlap each turn at

least 50 percent so there is a double thickness over all areas. See Figure 7 on page 51.

Figure 7. Applying the coax seal tape before smoothing.

Use your fingers to mold and form the coax seal tape around the cable and connector to form a smooth, neat

surface. Be sure to squeeze out any air pockets. See Figure 8 on page 52

Note. Do not use plastic or vinyl electrical tape on the connectors because it will

deteriorate during long-term exposure to ultraviolet light and extreme weather.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 119 120

Keine Kommentare

Nortel WLAN Security Switch 2361 Installationsanleitung Seite 51